Step1: Shave the beret all around by equal force until you see the stitching but pay attention to the interior side in case of shaving it through. Shaving a beret can make it thin to be easily shaped when it’s wet.

Step2: Place the beret on with the adjustable ribbon to the rear. The band should be one finger above your eyebrows. Tie the straps in a bow then put the extra into the band or stitch it flat.

Step3: Draft form of a beret and remember from left to right. I have badges, place the badge 1mm above the band and stick it to the plastic flap. Test and adjust until you get it right.

Step4: Dunk your beret in warm water for 15-20 minutes—do not use hot or boiling water, as this can cause the wool to shrink. If the band is leather, try not to get the band wet. Place the wet beret on your head and adjust it to be properly fit. Don’t forget to put a towel around your neck in case of getting your body wet. Press the excess fabric in the folds and continue to shape until it becomes semi-dry in 15-20minutes. Then take it off and put it on somewhere to let it completely dry.

Step5: Test and adjust it. If it’s right, repeat step 4.